FRONT WIPER MOTOR REMOVAL

PROCEDURE


  1. REMOVE FRONT WIPER ARM HEAD CAP


    1. A00Y9ZKC01
      *a Protective Tape

      Using a screwdriver, disengage the 3 claws and remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side and LH side.

  2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH


    1. A00Y660

      Remove the nut and windshield wiper arm and blade assembly LH.

  3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH


    1. A00Y8PT

      Remove the nut and windshield wiper arm and blade assembly RH.

  4. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    1. A00Y8X8

      Disengage the 2 claws.

    2. A00Y5RFC01
      A00Y4VF Double-sided Tape

      Disengage the 3 guides, separate the double-sided tape and remove the front fender to cowl side seal LH as shown in the illustration.

  5. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE FRONT NO. 2 SIDE PANEL PROTECTOR LH


    1. A00Y8F6

      Remove the clip.

    2. Disengage the claw and remove the front No. 2 side panel protector LH.

  7. REMOVE FRONT NO. 2 SIDE PANEL PROTECTOR RH


    1. A00YAWK

      Remove the clip.

    2. Disengage the 2 claws and remove the front No. 2 side panel protector RH.

  8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. Remove the 2 clips.

      A00Y7YZ

    2. Disengage the 6 claws and 3 guides as shown in the illustration.

      A00Y514

    3. Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

      A00Y9W4

  9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. A00YAPI

      Disengage the 2 clamps.

    2. Remove the 2 bolts.

    3. A00Y9IWC01
      *a Motor Grommet

      Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

      Note

      Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.

    4. A00YAIB

      Disconnect the connector.

  10. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A00YAQRC01
      *a Protective Tape
      *b Windshield Wiper Crank Pivot

      Using a screwdriver, separate the No. 1 windshield wiper link rod from the windshield wiper crank pivot of the windshield wiper motor and link assembly as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A00YAWV

      Remove the 3 bolts and windshield wiper motor assembly from the windshield wiper link assembly.

      Tech Tips

      If the windshield wiper motor assembly cannot be removed from the windshield wiper link assembly, turn the crank arm so that the windshield wiper motor assembly can be removed.