POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative(-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY BOX COVER

    for Hatchback: Click here

    for Wagon: Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR ARMREST ASSEMBLY

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER


    1. A01KT21

      Disconnect the connector.

    2. Remove the rear door service hole cover.

      Click here

  8. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  9. DISCONNECT REAR DOOR GLASS RUN

    Click here

  10. REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR GLASS RUN

    Click here

  13. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

    Click here