REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note

      Keep the lip free from foreign matter.

    3. A01KR3GN07

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Wipe any extra grease off of the crankshaft.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. A01KU0DN01

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    3. A01KRANC27
      *a Adhesive

      Apply adhesive to the 2 or 3 threads at the tip of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    4. A01KT80N02

      Using several steps, uniformly install and tighten the 8 bolts in the order shown in the illustration.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }
    5. A01KTZSC01
      A01KSBW Paint Mark

      Mark the front of the bolts with paint.

    6. Further tighten the 8 bolts 90° in the same order.

    7. Check that the paint marks are now at a 90° angle to the front.

    8. Check that the crankshaft turns smoothly.

  3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. A01KU0DN01

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

    3. Install the transmission input damper assembly.

    4. A01KR7BN01

      In several steps, uniformly install and tighten the 6 bolts in the order shown in the illustration.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Do not insert the transmission input damper assembly in the wrong direction.

  4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here