REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. A00YMN2N04

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    3. A00YPSM

      Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. A00YMN2N05

      Using SST, hold the crankshaft pulley.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    3. A00YNKV

      Remove the 8 bolts and flywheel sub-assembly.

  4. REMOVE REAR ENGINE OIL SEAL


    1. Gently place the engine assembly on wooden blocks or equivalent.

      Note

      This step should be done while hanging the engine assembly using the engine hangers and a chain block.

    2. A00YQ3OC07
      *a Cut Position
      *b Protective Tape

      Using a knife, cut off the rear engine oil seal lip.

    3. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.

      Note

      After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.