FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Keep the lip free from foreign matter.

    2. A01KT6LN03

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the front timing chain cover oil seal retainer edge.

      SST
      09223-22010

      Note


      • Wipe any extra grease off of the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the crankshaft pulley set key with the key groove of the crankshaft pulley.

    2. Install the crankshaft pulley to the crankshaft.

    3. A01KTN6C02
      *a Hold
      A01KRLR Turn

      Using SST, hold the crankshaft pulley in place and tighten the bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT FOR OIL LEAK

  6. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER


    1. Install the No. 1 engine under cover with the 6 screws and 11 clips.