FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL RH

  2. REMOVE NO. 1 ENGINE UNDER COVER


    1. Remove the 6 screws, 11 clips and No. 1 engine under cover.

  3. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  4. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  5. REMOVE CRANKSHAFT PULLEY


    1. A00YMJ2C02
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley in place and loosen the pulley bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    2. A00YMO4C02
      *a Hold
      *b Turn

      Using SST, remove the crankshaft pulley and pulley bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

  6. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A00YO5OC03
      *a Protective Tape
      *b Cut Position

      Using a knife, cut off the lip of the timing chain cover oil seal.

    2. Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain cover oil seal.

      Note

      After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.