FRAME WIRE REMOVAL

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE INVERTER WITH CONVERTER ASSEMBLY

    Click here

  3. REMOVE REAR SEAT CUSHION ASSEMBLY



  4. REMOVE REAR UNDER SIDE COVER LH



  5. REMOVE REAR UNDER SIDE COVER RH



  6. REMOVE REAR UNDER COVER

    Click here

  7. REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY

    Click here

  8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  9. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  10. REMOVE FRONT FLOOR COVER RH


    1. A01KR6HN01

      Remove the bolt.

    2. Remove the clip (A).

    3. Disconnect the 3 clips (B) and remove the front floor cover RH.

  11. REMOVE FRONT CENTER FLOOR COVER RH


    1. A01KRS2

      Disconnect the 2 clips and remove the front center floor cover RH.

  12. REMOVE REAR FLOOR SIDE MEMBER COVER RH

    Click here

  13. REMOVE FRONT SUSPENSION MEMBER REAR BRACE RH

    Tech Tips

    Perform the same procedure as the LH side.

    Click here

  14. REMOVE HYBRID BATTERY COVER SUB-ASSEMBLY RH

    Click here

  15. REMOVE FRAME WIRE

    CAUTION:

    Wear insulated gloves.

    Note

    Insulate the removed connectors with insulating tape.


    1. A01KRXNC01
      *a Shielded Wire Ground

      Disconnect the 3 frame wire connectors.

    2. Disconnect the shielded wire ground.

    3. A01KSG0

      Disconnect the 3 claws and push the frame wire out from the floor panel.

    4. A01KT8I

      Disconnect the No. 1 engine room relay block and No.1 junction block assembly connector from the No. 1 engine room relay block and No.1 junction block assembly.

    5. Disconnect the 3 clamps.

    6. A01KTQ8

      Disconnect the clamp.

    7. A01KTKZ

      Remove the nut and heater water pipe sub-assembly.

    8. A01KREOC01
      *A for RHD
      *B for LHD

      Remove the nut and 2 clamps.

    9. A01KRH4

      Remove the nut and clamp.

    10. A01KT4W

      Remove the nut.

    11. Disconnect the 4 clamps and remove the frame wire.

      A01KSO7

      Note

      The clamps are non-reusable parts.