FRAME WIRE REMOVAL

PROCEDURE

1. PRECAUTION

   Click here

2. REMOVE INVERTER WITH CONVERTER ASSEMBLY

   Click here

3. REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

4. REMOVE REAR UNDER SIDE COVER LH

   Click here

5. REMOVE REAR UNDER SIDE COVER RH

   Click here

6. REMOVE REAR UNDER COVER

   Click here

7. REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY

   Click here

8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

   Click here

9. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

   Click here

10. REMOVE FRONT FLOOR COVER RH

    
    

    1. 

       Remove the bolt.

    2. Remove the clip (A).

    3. Disconnect the 3 clips (B) and remove the front floor cover RH.

11. REMOVE FRONT CENTER FLOOR COVER RH

    
    

    1. 

       Disconnect the 2 clips and remove the front center floor cover RH.

12. REMOVE REAR FLOOR SIDE MEMBER COVER RH

    Click here

13. REMOVE FRONT SUSPENSION MEMBER REAR BRACE RH

    Tech Tips

    Perform the same procedure as the LH side.

    Click here

14. REMOVE HYBRID BATTERY COVER SUB-ASSEMBLY RH

    Click here

15. REMOVE FRAME WIRE

    CAUTION:

    Wear insulated gloves.

    Note

    Insulate the removed connectors with insulating tape.

    
    

    1. 

       *a	Shielded Wire Ground

       Disconnect the 3 frame wire connectors.

    2. Disconnect the shielded wire ground.

    3. 

       Disconnect the 3 claws and push the frame wire out from the floor panel.

    4. 

       Disconnect the No. 1 engine room relay block and No.1 junction block assembly connector from the No. 1 engine room relay block and No.1 junction block assembly.

    5. Disconnect the 3 clamps.

    6. 

       Disconnect the clamp.

    7. 

       Remove the nut and heater water pipe sub-assembly.

    8. 

       *A	for RHD
       *B	for LHD

       Remove the nut and 2 clamps.

    9. 

       Remove the nut and clamp.

    10. 

        Remove the nut.

    11. Disconnect the 4 clamps and remove the frame wire.

        

        Note

        The clamps are non-reusable parts.