HYBRID CONTROL SYSTEM, Diagnostic DTC:P0AA7-727

DTC Code DTC Name
P0AA7-727 Hybrid Battery Voltage Isolation Sensor Circuit

DESCRIPTION

The power management control ECU monitors the insulation monitoring circuit located in the battery voltage sensor and detects a malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0AA7-727 Hybrid Battery Voltage Isolation Sensor Circuit Malfunction in the insulation monitoring circuit in the battery voltage sensor Battery voltage sensor Does not come on

Master Warning Light:

Comes on

PROCEDURE


  1. CLEAR DTC

    Result
    Proceed to
    NEXT

    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Clear the DTCs and freeze frame data.


      Powertrain > Hybrid Control > Clear DTCs

    5. Turn the power switch off.

      Result
      Proceed to
      NEXT

    NEXT

  2. SIMULATION TEST


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG) and wait for 1 minute or more.

      Note

      Do not turn the power switch off until step 3 is complete.

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Check if DTCs are output.


      Powertrain > Hybrid Control > Trouble Codes
      Result
      Proceed to
      P0AA7-727 is not output.
      P0AA7-727 is output.

    P0AA7-727 is output.

    REPLACE BATTERY VOLTAGE SENSOR Click here

    P0AA7-727 is not output.

  3. SIMULATION TEST

    Note

    Do not turn the power switch off while performing this inspection.


    1. With the vehicle and engine stopped, turn the power switch on (READY) with the shift lever in P and wait for 1 second or more. (If the engine starts, wait until the engine stops.)

    2. While depressing the brake pedal without depressing the accelerator pedal, move the shift lever to D and wait for 1 minute. (Step A)

    3. Drive the vehicle 0.5 m (1.6 ft.) forward and perform step A.

    4. Drive the vehicle another 0.5 m (1.6 ft.) forward and perform step A. Repeat this procedure 5 times (minimum total driving distance: 2 m (6.6 ft.)).

    5. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    6. Check if DTCs are output.


      Powertrain > Hybrid Control > Trouble Codes
      Result
      Proceed to
      P0AA6 is not output.
      P0AA6 is output.

    P0AA6 is not output.

    REPLACE BATTERY VOLTAGE SENSOR Click here

    P0AA6 is output.

    GO TO DTC CHART (P0AA6) Click here