AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   
   
   1. 

      *a	Length of SST 30 mm (1.18 in.)
      *b	Length of Torque Wrench 300 mm (11.8 in.)

      Using SST, install the air fuel ratio sensor to the exhaust manifold.

      SST

      09224-00010

      Torque:

      without SST [Torque (N*m(kgf*cm, ft.*lbf))]

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]

      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips

      
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

   2. Connect the air fuel ratio sensor connector.

   3. Engage the clamp.

2. INSTALL NO. 2 CYLINDER HEAD COVER

   Click here

3. INSPECT FOR EXHAUST GAS LEAK

4. INSTALL OUTER COWL TOP PANEL (for LHD)

   Click here

5. INSTALL OUTER COWL TOP PANEL (for RHD)

   Click here

6. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

   Click here

7. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

   Click here

8. INSTALL WATER GUARD PLATE LH (for LHD)

   Click here

9. INSTALL WATER GUARD PLATE LH (for RHD)

   Click here

10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here