REAR LOWER ARM INSPECTION

PROCEDURE


  1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

    A00YB70

    1. Inspect the turning torque of the ball joint.


      1. Secure the rear No. 1 suspension arm assembly between aluminum plates in a vise.

        Note

        Do not overtighten the vise.

      2. Install the installation nut to the ball joint stud.

      3. Move the stud back and forth 5 times. Using a torque wrench, turn the stud continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

        Standard Turning Torque
        0.5 to 3.4 N*m (5.1 to 34 kgf*cm, 4.4 to 30 in.*lbf)

        If the turning torque is not within the specified range, replace the rear No. 1 suspension arm assembly with a new one.

    2. Check the dust boots for cracks or grease leakage.