REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with new 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. CONNECT SKID CONTROL SENSOR WIRE

    Click here

  3. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  4. INSPECT REAR AXLE HUB RUNOUT

    Click here

  5. INSTALL REAR DISC

    Click here

  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  8. INSTALL PARKING BRAKE LEVER PROTECTOR

    Click here

  9. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

    2. Connect the reservoir level switch connector.

    3. Clear the DTCs.

      Click here

  10. ADJUST PARKING BRAKE

    Click here

  11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  12. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  13. CHECK FOR SPEED SENSOR SIGNAL

    Click here