SHIFT CONTROL ACTUATOR INSTALLATION

PROCEDURE


  1. INSTALL SHIFT CONTROL ACTUATOR SEAL

    Note

    It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.

    Tech Tips

    Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.


    1. A00YPEXE01

      Using SST and a hammer, tap in a new shift control actuator seal.

      SST
      09820-00031
      Seal Installation Depth
      8.5 to 9.8 mm (0.335 to 0.386 in.)

  2. INSTALL SHIFT CONTROL ACTUATOR ASSEMBLY


    1. A00YN8Y

      Install the shift control actuator assembly to the hybrid vehicle transaxle assembly with 3 new shift control actuator bolts.

      Torque:
      9.5 N*m  { 97 kgf*cm, 84 in.*lbf }
    2. A00YNFK

      Install 3 new shift control actuator bolt caps to the 3 shift control actuator bolts.

      Note

      Push in each shift control actuator bolt cap firmly until the claw of the shift control actuator bolt cap engages with the shift control actuator bolt.

    3. Connect the shift control actuator assembly connector.

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click here