SHIFT LEVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • If the transmission floor shift assembly is to be replaced with a new one, it is necessary to clear the learned shift sensor voltage values by disconnecting and reconnecting the cable of the negative (-) auxiliary battery terminal.

    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

      Click here

  2. REMOVE BATTERY BOX COVER (for Wagon)

    Click here

  3. REMOVE BATTERY BOX COVER (for Hatchback)

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSTALL SHIFT LEVER KNOB


    1. A01KRC6

      Apply protective tape around the transmission floor shift assembly.

      Note

      As adhesive residue may fall when removing the shift lever knob, apply protective tape.

    2. A01KT5C

      Turn the shift lever knob in the direction of the arrow in the illustration to remove it.

  6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  8. REMOVE UPPER CONSOLE PANEL

    Click here

  9. REMOVE LOWER CONSOLE COVER

    Click here

  10. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. A01KSH2

      Disconnect the transmission floor shift assembly connector.

    2. Remove the 3 nuts and transmission floor shift assembly from the shift lever support.