INPUT SHAFT OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE INPUT SHAFT TYPE T OIL SEAL


    1. A00YND6C04
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the input shaft type T oil seal from the hybrid vehicle transaxle assembly.

      Note

      When removing the input shaft type T oil seal, make sure not to damage the input shaft assembly or hybrid vehicle transaxle assembly.

  3. INSTALL INPUT SHAFT TYPE T OIL SEAL


    1. A00YPK8E01

      Coat the lip of a new input shaft type T oil seal with MP grease.

    2. Using SST and a hammer, tap in the input shaft type T oil seal to the hybrid vehicle transaxle assembly.

      SST
      09330-50010
      Oil Seal Installation Depth
      1.0 to 1.8 mm (0.0394 to 0.0709 in.)

      Note


      • Ensure that no foreign matter adheres to the input shaft type T oil seal lip.

      • Ensure that the input shaft type T oil seal is not at an angle.

  4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here