GENERATOR CABLE INSTALLATION

PROCEDURE


  1. INSTALL GENERATOR CABLE

    CAUTION:

    Wear insulated gloves.


    1. Install the generator cable to the hybrid vehicle transaxle assembly with the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Keep the sealing surfaces of the generator cable and the connector terminal joint free of foreign matter.

    2. Engage the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.

      Note

      When installing the terminal cap to the generator cable terminal block, keep the sealing surface free of foreign matter.

    3. A00YMPI

      Place the generator cable connector shell in position and install it with the 3 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    4. Connect the clamp to the motor cable bracket.

  2. INSTALL RADIATOR PIPE


    1. Install the radiator pipe to the hybrid vehicle transaxle assembly with the 2 bolts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

    2. Connect the No. 3 radiator hose, No. 4 water by-pass hose and No. 1 radiator hose to the radiator pipe and engine assembly, and slide the 3 clips to secure them.

  3. INSTALL INVERTER TRAY BRACKET

    Click here

  4. INSTALL INVERTER RESERVE TANK ASSEMBLY

    Click here

  5. INSTALL INVERTER WITH CONVERTER ASSEMBLY

    Click here

  6. ADD COOLANT (for Engine)

    Click here

  7. INSPECT COOLANT (for Engine)

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER

    Click here