ELECTRONIC SHIFT LEVER SYSTEM, Diagnostic DTC:C2311

DTC Code DTC Name
C2311 Communication Error from HV ECU

DESCRIPTION

The transmission control ECU assembly receives a P position switch signal from the hybrid vehicle control ECU assembly and activates the parking lock motor by controlling current, causing the parking lock mechanism to switch. The transmission control ECU assembly stores this DTC when it detects a communication error between the hybrid vehicle control ECU assembly and the transmission control ECU assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
C2311 Communication Error from HV ECU With the power switch on (IG) (IG circuit malfunction is not detected), a signal cannot be received from the hybrid vehicle control ECU assembly (open or short in the P control (PCON) terminal circuit) or a pulse signal malfunction is received from the hybrid vehicle control ECU assembly for 2 seconds or more.

  • Transmission control ECU assembly

  • Hybrid vehicle control ECU assembly

  • Wire harness or connector

  • Master Warning Light


    • Comes on


  • Multi-information Display Error Message


    • Comes on

 DTC stored

WIRING DIAGRAM

A01KRJ5E02
*a Hybrid Vehicle Control ECU Assembly
*b Transmission Control ECU Assembly

PROCEDURE


  1. CHECK TRANSMISSION CONTROL ECU ASSEMBLY


    1. Turn the power switch on (IG).

    2. A01KT99C03
      *a

      Component with harness connected

      (Transmission Control ECU Assembly)
      *b Waveform

      Connect an oscilloscope between the transmission control ECU assembly terminals specified in the table below, and measure the waveform.

      Item Contents
      Symbols A132-22 (PCON) - A132-1 (E1)
      Tool setting 10 V/DIV., 10 msec./DIV.
      Vehicle condition Power switch on (IG)
      OK
      The waveform is similar to that shown in the illustration.

      Tech Tips

      Perform this inspection with the connector connected.

    3. Turn the power switch off.

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE TRANSMISSION CONTROL ECU ASSEMBLY for LHD: Click here
    REPLACE TRANSMISSION CONTROL ECU ASSEMBLY for RHD: Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL ECU ASSEMBLY - HYBRID VEHICLE CONTROL ECU ASSEMBLY)


    1. Disconnect the A132 transmission control ECU assembly connector.

    2. Disconnect the E135 hybrid vehicle control ECU assembly connector.

    3. A01KS01C01
      *a

      Front view of wire harness connector

      (to Transmission Control ECU Assembly)
      *b

      Rear view of wire harness connector

      (to Hybrid Vehicle Control ECU Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      A132-22 (PCON) - E135-8 (PCON) Power switch off Below 1 Ω
      Standard Resistance (Check for Short)
      Tester Connection Condition Specified Condition
      A132-22 (PCON) or E135-8 (PCON) - Body ground and other terminals Power switch off 10 kΩ or higher

    4. Reconnect the E135 hybrid vehicle control ECU assembly connector.

    5. Reconnect the A132 transmission control ECU assembly connector.

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY for LHD: Click here
    REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY for RHD: Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR