ELECTRONIC SHIFT LEVER SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING THE CABLE FROM THE NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected:

    System See Procedure
    Simple Intelligent Parking Assist System

    Click here

    Power Door Lock Control System

  2. NOTICE FOR HYBRID SYSTEM ACTIVATION


    1. When the master warning light is illuminated or the auxiliary battery has been disconnected and reconnected, pressing the power switch may not start the hybrid system on the first try. If so, press the power switch again.

  3. CAN COMMUNICATION SYSTEM PRECAUTIONS


    1. The CAN communication system is used for data communication between the transmission control ECU assembly, the hybrid vehicle control ECU assembly and other ECUs. If there are any problems in the CAN communication lines, corresponding DTCs are output.

    2. If any CAN communication DTCs are output, repair the malfunction and troubleshoot the electronic shift lever system after data communication becomes normal.

  4. LIN COMMUNICATION SYSTEM PRECAUTIONS


    1. The LIN communication system is used for data communication between the transmission control ECU assembly, the certification ECU and other ECUs. If there are any problems in the LIN communication lines, park (P) cannot be disengaged.

    2. If any LIN communication DTCs are output, repair the malfunction and troubleshoot the electronic shift lever system after data communication becomes normal.

  5. DTC PRECAUTION


    1. It may not be possible to clear the following DTCs using the GTS: DTC C2300 (Actuator System Malfunction), C2301 (Shift Changing Time Malfunction), C2303 (Short in Power Source Relay Circuit), C2304 (Open or Short Circuit in U Phase), C2305 (Open or Short Circuit in V Phase), C2306 (Open or Short Circuit in W Phase), C2307 (Power Supply) and C2309 (Open in B+ Circuit). In such cases, disconnect the P-CON MAIN fuse and wait for at least 60 seconds to clear the DTCs after the repair.