ELECTRONIC SHIFT LEVER SYSTEM DTC CHECK / CLEAR


  1. CHECK FOR DTCS (Using the GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Transmission Control / Trouble Codes.

    5. Check for DTCs and freeze frame data, and then write them down.


      Body Electrical > Transmission Control > Trouble Codes

    6. Check the details of the DTCs.

    Tech Tips

    When a DTC is detected, the master warning light comes on and an error message is indicated on the multi-information display.

  2. CHECK FOR DTCS (Systems other than the transmission control ECU assembly)

    Tech Tips

    The transmission control ECU assembly maintains communication with other ECUs, including the hybrid vehicle control ECU assembly. Therefore, if the transmission control ECU assembly outputs a warning, it is necessary to check and record the DTCs of all systems.


    1. If DTCs are present, check the relevant systems.

      Tech Tips

      If DTCs for the CAN communication system are present in addition to other DTCs, first troubleshoot and repair any malfunctions in the CAN communication system.

  3. CLEAR DTCS (Using the GTS)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Transmission Control / Trouble Codes.

    5. Clear the DTCs and freeze frame data.


      Body Electrical > Transmission Control > Clear DTCs

      Note


      • It may not be possible to clear the following DTCs using the GTS: C2300 (Actuator System Malfunction), C2301 (Shift Changing Time Malfunction), C2303 (Short in Power Source Relay Circuit), C2304 (Open or Short Circuit in U Phase), C2305 (Open or Short Circuit in V Phase), C2306 (Open or Short Circuit in W Phase), C2307 (Power Supply) and C2309 (Open in B+ Circuit). In such cases, disconnect the P-CON MAIN fuse and wait for at least 60 seconds to clear the DTCs after the repair.

      • Clearing the DTCs will also clear the freeze frame data.

  4. CLEAR DTCS (Without using the GTS)


    1. Turn the power switch off.

    2. Remove the P-CON MAIN fuse from the No. 1 engine room relay block and No. 1 junction block assembly located inside the engine compartment for more than 60 seconds.

    3. Check for DTCs again to see if the DTCs are cleared.

      Note


      • If DTCs are output, repair the parts by following the diagnostic trouble code chart.

      • Clearing the DTCs will also clear the freeze frame data.