DATA LIST
Tech Tips
Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| CCS Vehicle Spd | Vehicle speed | min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed is displayed | - |
| CCS Mem Vehicle Spd | Stored vehicle speed | min.: 0 km/h (0 mph), max.: 255 km/h (159 mph) | Actual vehicle speed stored in memory | - |
| Cruise Control | Cruise control | ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated |
- |
| Main SW M-CPU | Cruise control switch (Main-CPU) | ON or OFF | ON: Cruise control switch (ON-OFF button) pushed OFF: Cruise control switch (ON-OFF button) released |
- |
| CCS Ready M-CPU | Cruise control system standby condition (Main-CPU) | ON or OFF | Each time cruise control switch (ON-OFF button) is pushed, ON/OFF changes | - |
| CCS Indicator M-CPU | Cruise control indicator (Main-CPU) | ON or OFF | ON: Cruise control indicator illuminated OFF: Cruise control indicator not illuminated |
- |
| Cancel Switch | CANCEL switch signal | ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off |
- |
| SET/COAST Switch | -/SET switch signal | ON or OFF | ON: -/SET switch on OFF: -/SET switch off |
- |
| RES/ACC Switch | +/RES switch signal | ON or OFF | ON: +/RES switch on OFF: +/RES switch off |
- |
| Stop Light Switch 1 | Stop light switch signal | ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Stop Light Switch 2 | Stop light switch signal | ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Cruise Operation Status | Shift position signal (D position) | ON or OFF | ON: Shift lever in D OFF: Shift lever not in D |
- |
| Cruise Request Driving Force | Cruise control driving force signal | min.: -51.2 kN, max.: 50.8 kN | Actual driving force | - |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the GTS, perform the "Active Test".
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | - |