ПЕРЕДНИЙ ПРИВОДНОЙ ВАЛ В СБОРЕ (для моделей с 1ND-TV) УСТАНОВКА

PROCEDURE

1. Click here

   INSTALL FRONT DRIVE SHAFT HOLE SNAP RING

   
   

   1. Install a new front drive shaft hole snap ring.

      Note:

      Face the end gap of the front drive shaft hole snap ring downward.

2. Click here

   INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

   
   

   1. Coat the splines of the front drive inboard joint assembly with gear oil.

   2. Coat the lip of the transmission case oil seal with MP grease.

   3. 

      Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.

      Note:
      

      • Face the end gap of the front drive shaft hole snap ring downward.

      • Do not damage the transmission case oil seal.

      • Do not damage the front axle inboard joint boot.

      • Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring.

      Tip:

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

   4. 

      *a

      Matchmark

      Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.

      Note:

      Be careful not to damage the front axle outboard joint boot.

3. Click here

   INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

   Tip:

   Perform the same procedure as for the LH side.

4. Click here

   CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

   Click here

5. Click here

   INSTALL FRONT STABILIZER LINK ASSEMBLY

   Click here

6. Click here

   CONNECT TIE ROD END SUB-ASSEMBLY

   Click here

7. Click here

   INSTALL FRONT FLEXIBLE HOSE

   Click here

8. Click here

   INSTALL FRONT SPEED SENSOR

   Click here

9. Click here

   INSTALL FRONT AXLE SHAFT NUT

   
   

   1. Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.

      Note:
      

      • Be sure to perform this work even when using a new drive shaft.

      • Keep the threaded parts free of oil and foreign matter.

   2. 

      Using a 30 mm socket wrench, install the front axle shaft nut.

      216 N*m

      2203 kgf*cm

      159 ft.*lbf

      Tip:

      Keep depressing the brake pedal to prevent the drive shaft from rotating.

   3. Using a chisel and a hammer, stake the front axle shaft nut.

10. Click here

    ADD MANUAL TRANSAXLE OIL

    for Manual Transaxle:Click here

    for Multi-Mode Manual Transaxle:Click here

11. Click here

    INSPECT FOR OIL LEAK

12. Click here

    INSTALL REAR ENGINE UNDER COVER LH

13. Click here

    INSTALL REAR ENGINE UNDER COVER RH

14. Click here

    INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

15. Click here

    INSTALL FRONT WHEELS

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

16. Click here

    ADJUST FRONT WHEEL ALIGNMENT

    Click here

17. Click here

    CHECK FOR SPEED SENSOR SIGNAL

    w/o VSC:Click here

    w/ VSC:Click here