ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ (для моделей изготовления TMMT) СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. REMOVE BATTERY

    Click here

  9. REMOVE BATTERY CARRIER ASSEMBLY

    Click here

  10. REMOVE FRONT CENTER FLOOR BRACE SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

    Click here

  12. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    1. A01M205

      Remove the 3 nuts and front No. 1 floor heat insulator from the vehicle body.

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01M0SW

      Disconnect the transmission control cable assembly from the shift lever assembly.

    3. A01LXG2C03
      *a Stopper

      Using a screwdriver, pull out the stopper of the transmission control cable assembly.

      Note

      Do not remove the stopper. If it is removed, reinstall it to its original position.

    4. A01LXGBC03
      *a Nut
      *b Turn approximately 180°

      Turn the nut of the transmission control cable assembly approximately 180° counterclockwise and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

      Note

      Do not turn the nut excessively as the internal spring may come off and the transmission control cable assembly will not be reusable.

    5. A01LZPC

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    7. A01LV74

      Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting insulator.

    8. A01M1N3

      Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.