ДАТЧИК ВЫБОРА ПЕРЕДАЧ УСТАНОВКА

PROCEDURE


  1. INSTALL SELECT STROKE SENSOR


    1. Apply MP grease to a new O-ring.

    2. Install the O-ring to the select stroke sensor.

    3. A01T93G

      Set the select stroke sensor so that the sensor side and actuator side sensor arms are positioned as shown in the illustration.

    4. Turn the select stroke sensor clockwise.

    5. Install the 2 screws.

      Torque:
      1.3 N*m  { 13 kgf*cm, 12 in.*lbf }

    6. Connect the select stroke sensor connector.

    7. Connect the 2 wire harness clamps.

  2. INSTALL AIR CLEANER BRACKET

    Click here

  3. INSTALL FUEL FILTER SUPPORT

    Click here

  4. CONNECT ENGINE WIRE

    Click here

  5. INSTALL FUEL FILTER ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  7. PERFORM INITIALIZATION OF MULTI-MODE MANUAL TRANSAXLE SYSTEM

    Click here

  8. PERFORM LEARNING OF MULTI-MODE MANUAL TRANSAXLE SYSTEM

    Click here

  9. PERFORM SYNCHRONIZATION POSITION CALIBRATION

    Click here