ДАТЧИК ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ ПРОВЕРКА

PROCEDURE


  1. INSPECT SHIFT STROKE SENSOR

    A00YAV2C03
    *a Main
    *b Shift Stroke Sensor Arm
    *c 55°
    *d 0°
    *e -55°

    1. Measure the voltage between the terminals of the shift stroke sensor connector (main).


      1. Prepare 3 dry cell batteries (1.5 V) and 2 leads for connecting the batteries and the sensor.

      2. Connect the batteries in series.

      3. Connect the positive battery terminal to sensor terminal 3 (VCS1), and the negative battery terminal to sensor terminal 2 (E2S1).

      4. Measure the voltage according to the value(s) in the table below.

        Standard Voltage (combined dry cell battery voltage of 4.5 V)
        Tester Connection Condition (Sensor Angle) Specified Condition
        1 (VSS1) - 2 (E2S1) 55° 3.6 to 4.5 V
        0° 1.8 to 2.7 V
        -55° 0.27 to 0.63 V
        Reference Voltage (combined dry cell battery voltage of 5.0 +/- 0.3 V)
        Tester Connection Sensor Angle Specified Condition
        1 (VSS1) - 2 (E2S1) 55° 4.0 to 5.0 V
        0° 2.0 to 3.0 V
        -55° 0.3 to 0.7 V

        Note


        • Do not apply more than 6 V.


        • Do not use a sensor which has been dropped.

        If the voltage is not as specified, replace the shift stroke sensor.

    2. A00YAV2C04
      *a Sub
      *b Shift Stroke Sensor Arm
      *c 55°
      *d 0°
      *e -55°

      Measure the voltage between the terminals of the shift stroke sensor connector (sub).


      1. Connect the positive battery terminal to sensor terminal 6 (VCS2) , and the negative battery terminal to sensor terminal 5 (E2S2).

      2. Measure the voltage according to the value(s) in the table below.

        Standard Voltage (combined dry cell battery voltage of 4.5 V)
        Tester Connection Condition (Sensor Angle) Specified Condition
        4 (VSS2) - 5 (E2S2) 55° 3.6 to 4.5 V
        0° 1.8 to 2.7 V
        -55° 0.27 to 0.63 V
        Reference Voltage (combined dry cell battery voltage of 5.0 +/- 0.3 V)
        Tester Connection Sensor Angle Specified Condition
        4 (VSS2) - 5 (E2S2) 55° 4.0 to 5.0 V
        0° 2.0 to 3.0 V
        -55° 0.3 to 0.7 V

        Note


        • Do not apply more than 6 V.


        • Do not use a sensor which has been dropped.

        If the voltage is not as specified, replace the shift stroke sensor.