МАСЛО ДЛЯ МЕХАНИЧЕСКОЙ ТРАНСМИССИИ "MULTIMODE" ЗАМЕНА

PROCEDURE

1. Click here

   REMOVE NO. 1 ENGINE UNDER COVER

   Click here

2. Click here

   REMOVE REAR ENGINE UNDER COVER LH

   Click here

3. Click here

   DRAIN MANUAL TRANSAXLE OIL

   
   
   1. 

      *1	Manual Transmission Filler Plug
      *2	Manual Transmission Drain Plug

      Remove the manual transmission filler plug and gasket.

   2. Using a 10 mm hexagon socket wrench, remove the manual transmission drain plug and gasket to drain the manual transaxle oil.

   3. Using a 10 mm hexagon socket wrench, install a new gasket and the manual transmission drain plug.

      45 N*m

      459 kgf*cm

      33 ft.*lbf

4. Click here

   ADD MANUAL TRANSAXLE OIL

   
   
   1. 

      *a

      0 to 5 mm

      Add manual transaxle oil until the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the transmission filler plug opening.

      Manual Transaxle Oil
      Toyota Genuine Manual Transmission Gear Oil "LV GL-4 and SAE 75W" or "API GL-4 and SAE 75W"

      Standard Capacity
      2.4 liters (2.5 US qts, 2.1 Imp.qts.)

   2. Install a new gasket and the transmission filler plug.

      39.2 N*m

      400 kgf*cm

      29 ft.*lbf

      Note:
      

      • When adding manual transaxle oil, make sure that the vehicle is level.

      • An excessively large or small amount of manual transaxle oil may cause problems.

      • After adding manual transaxle oil, drive the vehicle and recheck the oil level.

5. Click here

   INSPECT FOR OIL LEAK

6. Click here

   INSTALL REAR ENGINE UNDER COVER LH

   Click here

7. Click here

   INSTALL NO. 1 ENGINE UNDER COVER

   Click here