ГЕНЕРАТОР ПОВТОРНАЯ СБОРКА

PROCEDURE


  1. INSTALL GENERATOR ROTOR ASSEMBLY


    1. A01XH4RE01

      Using SST and a press, press in the generator rotor.

      SST
      09285-76010

    2. Place the washer on the generator rotor.

  2. INSTALL GENERATOR RECTIFIER END FRAME


    1. A01XET0E01
      Text in Illustration
      *1 17 mm Socket Wrench

      Using a 17 mm socket wrench and press, slowly press on the rectifier end frame.

    2. Install the cord clip and 4 nuts.

      Torque:
      5.9 N*m  { 60 kgf*cm, 52 in.*lbf }

  3. INSTALL GENERATOR HOLDER WITH RECTIFIER


    1. A01XKWC

      Install the 4 rubber insulators to the lead wires.

      Text in Illustration
      B001CHY Inside

      Note

      Be careful to install the rubber insulators in the correct direction.

    2. A01XLMD

      While pushing down on the rectifier holder, install it with the 4 screws.

      Torque:
      2.9 N*m  { 30 kgf*cm, 26 in.*lbf }
      Text in Illustration
      B001CHY Push

  4. INSTALL GENERATOR REGULATOR ASSEMBLY


    1. Install the regulator with the 3 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

  5. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    1. Install the plate seal.

    2. A01XD47

      Install the brush holder with the 2 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }
      Text in Illustration
      B001CHY Upper

    3. Install the brush holder cover.

  6. INSTALL GENERATOR REAR END COVER


    1. A01XGEYE01
      Text in Illustration
      *1 Rectifier Plate

      Install the rear end cover and rectifier plate with the bolt and 3 nuts.

      Torque:
      for nut
      4.4 N*m  { 45 kgf*cm, 39 in.*lbf }
      for bolt
      3.9 N*m  { 40 kgf*cm, 35 in.*lbf }

    2. Install the terminal insulator with the nut.

      Torque:
      4.1 N*m  { 42 kgf*cm, 36 in.*lbf }

  7. INSTALL VACUUM PUMP ASSEMBLY


    1. Align the matchmarks and install the vacuum pump with the 4 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }