ГЕНЕРАТОР СНЯТИЕ

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FAN AND GENERATOR V BELT


    1. Remove the fan and generator V belt Click here.

  3. DISCONNECT COOLER COMPRESSOR ASSEMBLY

    Click here

  4. REMOVE GENERATOR ASSEMBLY


    1. B001DS0

      Remove the terminal cap.

    2. Remove the nut and generator wire.

    3. Disconnect the generator connector.

    4. B001GZ1

      Disconnect the vacuum pump hose.

    5. Remove the union bolt to disconnect the vacuum pump oil inlet hose and remove the 2 gaskets.

    6. Detach the vacuum pump oil inlet hose from the cord clip.

    7. Disconnect the vacuum pump oil outlet hose.

    8. B001IL5

      Remove the 2 bolts and generator.