СТАРТЕР УСТАНОВКА

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly with the 2 bolts and nut.

      Torque:

      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

   2. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   3. Install the terminal cap.

   4. Connect the starter connector.

2. CONNECT CLUTCH FLEXIBLE HOSE BRACKET

   
   

   1. Connect the clutch flexible hose bracket with the bolt.

      Torque:

      72 N*m  { 730 kgf*cm, 53 ft.*lbf }

3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

   Click here

4. INSTALL REAR ENGINE UNDER COVER ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.