НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ УСТАНОВКА

PROCEDURE


  1. INSTALL WATER PUMP ASSEMBLY


    1. Install a new gasket, the water pump and tension spring bracket with the 6 bolts.

      Torque:
      23 N*m  { 236 kgf*cm, 17 ft.*lbf }

  2. INSTALL TIMING BELT


    1. Install the timing belt Click here.

  3. INSTALL NO. 2 IDLE PULLEY ASSEMBLY

    Click here

  4. CONNECT COMPRESSOR AND MAGNETIC CLUTCH

    Click here

  5. INSTALL FAN SHROUD


    1. Install the fan pulley to the water pump.

    2. Install the shroud together with the coupling fan between the radiator and engine.

      Note

      Be careful not to damage the radiator core.

    3. Temporarily install the fluid coupling fan to the fan pulley with the 4 nuts. Tighten the nuts as much as possible by hand.

    4. B001FLD

      Attach the claws of the shroud as shown in the illustration.

    5. Install the shroud with the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    6. Install the fan and generator V belt and vane pump V belt Click here.

    7. Tighten the 4 nuts of the fluid coupling fan.

      Torque:
      19 N*m  { 189 kgf*cm, 14 ft.*lbf }

  6. INSTALL RADIATOR RESERVOIR


    1. Install the radiator reservoir with the 3 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Connect the radiator reservoir hose to the radiator tank side.

  7. INSTALL NO. 2 RADIATOR HOSE


    1. B001GGRE02
      Text in Illustration
      *a Upper
      *b Front Side of Vehicle
      *c LH Side
      *1 Protrusion
      *2 Paint Mark

      Install the radiator hose.

      Tech Tips

      Position the hose clamps as shown in the illustration.

  8. INSTALL NO. 1 RADIATOR HOSE


    1. Install the hose clamp with the 2 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    2. B001EFOE02
      Text in Illustration
      *a Upper
      *b RH Side

      Install the radiator hose.

      Tech Tips

      Position the hose clamps as shown in the illustration.

  9. INSTALL RESONATOR WITH AIR CLEANER CAP

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. ADD ENGINE COOLANT

    Click here

  12. INSPECT FOR ENGINE COOLANT LEAK

    Click here

  13. INSTALL REAR ENGINE UNDER COVER ASSEMBLY

    Click here

  14. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  15. INSTALL FRONT BUMPER COVER LOWER

    Click here

  16. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here