НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ СНЯТИЕ

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE FRONT BUMPER COVER LOWER

    Click here

  5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE REAR ENGINE UNDER COVER ASSEMBLY

    Click here

  7. REMOVE RESONATOR WITH AIR CLEANER CAP

    Click here

  8. REMOVE NO. 1 RADIATOR HOSE


    1. B001D3L

      Detach the clamp and remove the No. 1 radiator hose.

    2. B001GBD

      Remove the 2 nuts and hose clamp.

  9. REMOVE NO. 2 RADIATOR HOSE

    B001HA1

  10. REMOVE RADIATOR RESERVOIR


    1. B001D0F

      Disconnect the reservoir hose from the upper side of the radiator tank.

    2. Remove the 3 bolts and radiator reservoir.

  11. REMOVE FAN SHROUD


    1. B001HM5

      Loosen the 4 nuts holding the fluid coupling fan.

    2. Remove the vane pump V belt and the fan and generator V belt Click here.

    3. B001H1Q

      Remove the 2 bolts holding the fan shroud.

    4. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

      Note

      Be careful not to damage the radiator core.

    5. Remove the fan pulley from the water pump.

  12. DISCONNECT COMPRESSOR AND MAGNETIC CLUTCH

    Click here

  13. REMOVE NO. 2 IDLE PULLEY ASSEMBLY

    Click here

  14. REMOVE TIMING BELT


    1. Remove the timing belt Click here.

  15. REMOVE WATER PUMP ASSEMBLY


    1. B001HWA

      Remove the 6 bolts and tension spring bracket.

    2. Remove the water pump and gasket.