ВПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

PROCEDURE


  1. REMOVE INTAKE PIPE


    1. A01XKXN

      Loosen the hose clamp and remove the 2 bolts and intake pipe.

  2. REMOVE INTAKE FLANGE


    1. A01XKSF

      Remove the bolt and disconnect the PCV hose and heater hose bracket.

    2. A01XDYY

      Disconnect the manifold absolute pressure sensor connector.

    3. A01XCLD

      Remove the 3 nuts, intake flange and gasket.

  3. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    1. A01XFY7

      Disconnect the throttle open switch connector.

    2. Remove the 2 bolts and disconnect the wire harness bracket.

    3. A01XK95

      Disconnect the throttle control motor connector.

    4. Remove the diesel throttle body and gasket.

  4. REMOVE INJECTION PIPE


    1. B001CK0

      Using a 17 mm union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

    2. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the 2 lower pipe clamps.

  5. REMOVE INTAKE MANIFOLD


    1. A01XF1N

      Remove the bolt and disconnect the wire harness bracket.

    2. A01XL6B

      Remove the 6 bolts, 2 nuts, intake manifold and gasket.