ДАТЧИК УРОВНЯ ТОПЛИВА В СБОРЕ УСТАНОВКА

PROCEDURE


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01XJ7CE01
      Text in Illustration
      *1 Fuel Sub-Tank
      B001CHY Slide

      Set the fuel sender gauge assembly on the fuel sub-tank. Then slide the fuel sender gauge assembly downward to install it.

    2. Connect the fuel sender gauge assembly connector.

  2. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)


    1. A01XE6LE02
      Text in Illustration
      *1 Fuel Gauge Support
      B001CHY Slide

      Set the fuel sender gauge assembly on the fuel gauge support. Then slide the fuel sender gauge assembly upward to install it.

      Note

      Make sure the part labeled A in the illustration is securely inserted into the hole of the fuel gauge support before sliding the fuel sender gauge assembly upward.

    2. A01XMKUE01
      Text in Illustration
      *1 Lead Wire (Black)
      *2 Lead Wire (Red)

      Install the 2 lead wires with the 2 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

      Note

      Be sure to install the lead wires in the correct locations according to their color as shown in the illustration.

  3. INSTALL FUEL TANK VENT TUBE ASSEMBLY


    1. for Single Tank Type:

      Install the fuel tank vent tube assembly Click here.

    2. for Double Tank Type:


      1. for Fuel Main Tank:

        Install the fuel tank vent tube assembly Click here.

      2. for Fuel Sub Tank:

        Install the fuel tank vent tube assembly Click here.