ТОПЛИВНАЯ ФОРСУНКА СНЯТИЕ

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE DIESEL THROTTLE BODY


    1. Remove the diesel throttle body Click here.

  3. REMOVE INJECTION PIPE SET


    1. B001CK0E04
      Text in Illustration
      *1 Union Nut Wrench
      *a for Injection Nozzle Side
      *b for Injection Pump Side

      Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

    2. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with 2 lower pipe clamps.

  4. REMOVE NO. 1 GLOW PLUG CONNECTOR

    Click here

  5. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY


    1. B001GPX

      Disconnect the fuel hose from the leakage pipe.

    2. Remove the 4 nuts, leakage pipe and 4 ring packing washers.

  6. REMOVE NOZZLE HOLDER AND NOZZLE SET


    1. B001C81E03

      Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.

      SST
      09268-64010   ( 09268-64020 )