БЛОК ДВИГАТЕЛЯ ПОВТОРНАЯ СБОРКА

PROCEDURE


  1. INSTALL REAR CRANKSHAFT OIL SEAL


    1. A01XMIDE04

      Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

    2. Apply MP grease to lip of the oil seal.

  2. INSTALL REAR CRANKSHAFT OIL SEAL RETAINER


    1. Install a new gasket and the retainer with the 4 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  3. INSTALL FRONT CRANKSHAFT OIL SEAL

    Click here

  4. INSTALL TIMING BELT CASE SUB-ASSEMBLY

    Click here

  5. INSTALL OIL STRAINER SUB-ASSEMBLY

    Click here

  6. INSTALL OIL PAN SUB-ASSEMBLY

    Click here

  7. INSTALL CRANKSHAFT TIMING PULLEY

    Click here

  8. INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

    Click here

  9. INSTALL WATER PUMP ASSEMBLY

    Click here

  10. INSTALL NO. 2 TIMING BELT IDLER SUB-ASSEMBLY


    1. Install the spacer and No. 2 timing belt idler with the bolt.

      Torque:
      33 N*m  { 337 kgf*cm, 24 ft.*lbf }

    2. Check that the No. 2 timing belt idler moves smoothly.

  11. INSTALL CYLINDER HEAD GASKET

    Click here

  12. INSTALL CYLINDER HEAD SUB-ASSEMBLY

    Click here

  13. INSTALL CAMSHAFT

    Click here

  14. INSTALL CAMSHAFT OIL SEAL

    Click here

  15. INSTALL CAMSHAFT OIL SEAL RETAINER

    Click here

  16. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY


    1. Remove any old packing (FIPG material).

    2. A01XLTIE06
      Text in Illustration
      *1 Seal Packing

      Apply seal packing to the cylinder head as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    3. Install the gasket to the cylinder head cover.

    4. Install the cylinder head cover with the 9 bolts and nut. Uniformly tighten the bolts and nut in several steps.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  17. INSTALL NO. 2 TIMING BELT COVER

    Click here

  18. INSTALL CAMSHAFT TIMING PULLEY

    Click here

  19. INSTALL CRANKSHAFT POSITION SENSOR

    Click here