СИСТЕМА ECD MIL Circuit

DESCRIPTION

The MIL is used to inform the user when the ECM has detected a vehicle malfunction.

By turning the ignition switch to ON, power is supplied to the MIL circuit and the ECM provides the circuit ground that illuminates the MIL.

Operation of the MIL should be checked visually: When the ignition switch is first turned to ON, the MIL should illuminate. When the engine is started, the MIL should turn off.

WIRING DIAGRAM

B001COOE07

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK MIL CONDITION


    1. Check the MIL condition.

      Result
      Condition Proceed to
      MIL remains on A
      MIL does not illuminate B

    B

    CHECK IF MIL ILLUMINATES Click here

    A

  2. CHECK IF MIL TURNS OFF


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Check if DTCs have been stored Click here. If DTCs are stored, write them down.

    4. Clear the DTCs using the GTS Click here.

    5. Check that the MIL turns off.

      OK
      The MIL turns off.

    OK

    REPAIR CIRCUIT INDICATED BY OUTPUT DTC Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (FOR SHORT)


    1. Disconnect the ECM connector.

    2. Turn the ignition switch to ON.

    3. Check that the MIL is not illuminated.

      OK
      The MIL is not illuminated.

    4. Reconnect the ECM connector.


    OK

    REPLACE ECM Click here

    NG

  4. CHECK HARNESS AND CONNECTOR (ECM - COMBINATION METER ASSEMBLY)


    1. Disconnect the ECM connector.

    2. Disconnect the combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G182-13 (W) - G7-7 (CHK) Always Below 1 Ω
      G182-13 (W) or G7-7 (CHK) - Body ground Always 10 kΩ or higher

    4. Reconnect the ECM connector.

    5. Reconnect the combination meter assembly connector.


    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. CHECK IF MIL ILLUMINATES


    1. Check that the MIL illuminates when turning the ignition switch to ON.

      OK
      The MIL illuminates.

    OK

    NORMAL

    NG

  6. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)


    1. Refer to the combination meter assembly troubleshooting procedures Click here.


    OK

    REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - ECM)

    NG

    REPAIR OR REPLACE COMBINATION METER ASSEMBLY Click here