СИСТЕМА ECD ТАБЛИЦА РАБОТЫ В АВАРИЙНОМ РЕЖИМЕ

If any of the following DTCs are recorded, the ECM enters fail-safe mode.

DTC No. Detection Item Fail-Safe Operation Fail-Safe Deactivation Conditions
P0105 Manifold Absolute Pressure/Barometric Pressure Circuit Manifold absolute pressure is fixed at 101.3 kPa (760 mmHg, 30 in.Hg) Return to normal condition
P0115 Engine Coolant Temperature Circuit Engine coolant temperature is fixed at 9°C (48°F) Return to normal condition
P0180 Fuel Temperature Sensor "A" Circuit Fuel temperature is fixed at 20°C (68°F) Return to normal condition
P0335 Crankshaft Position Sensor "A" Circuit

  • Fuel cut

  • Timing control valve duty is fixed at 2%

  • Close throttle valve

 2 or more NE signals are detected for 0.5 second
P0340 Camshaft Position Sensor Circuit Timing control valve duty is fixed at 30% 2 or more TDC signals are detected for 4 engine revolutions
P0500 Vehicle Speed Sensor Vehicle speed is fixed at 0 km/h (0 mph) Vehicle speed is 10 km/h (6 mph) or less
P1115 Coolant Temperature Sensor Circuit for Coolant Heat Storage System / Intake Air Temperature Circuit Intake air temperature is fixed at 130°C (266°F) Return to normal condition
P1120 Throttle / Pedal Position Sensor/Coolant Flow Control Valve Position Sensor Circuit Output limit Ignition switch off
P1121 Throttle / Pedal Position Sensor/Coolant Flow Control Valve Position Sensor Circuit Stuck Output limit Ignition switch off
Accelerator pedal position below 22% Ignition switch off
P1222 Throttle Motor Circuit Range/Performance

  • Throttle valve is fully open

  • Accelerator pedal position below 25%

 Ignition switch off
P1225 Spill Control Circuit

  • Fuel cut

  • Close throttle valve

 Ignition switch off or starter on from off