OUTER REAR VIEW MIRROR (for TMC, TMMR Made) REASSEMBLY

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. INSTALL OUTER MIRROR RETRACTOR (for TMC Made)


    1. B000N6Q

      Install a new support as shown in the illustration.

    2. B000II6

      Pass a new wire harness through a new frame sub-assembly.

    3. B000HTQ

      Connect the connector.

    4. B000KWX

      Temporarily install the frame sub-assembly as shown in the illustration.

    5. B000MIC

      Install the frame sub-assembly with the 3 screws.

    6. Engage the clamp.

    7. B000ISZ

      Using a T25 "TORX" socket wrench, install the base with 3 new screws.

      Torque:
      3.8 N*m  { 39 kgf*cm, 34 in.*lbf }

      Note

      When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.

    8. Engage the clamp.

    9. B000M4T

      Engage the 5 claws to install a new lower cover.

    10. B000KJV

      Engage the 5 pins to install a new gasket.

    11. B000IH7E01
      Text in Illustration
      *a Marking

      Adjust the wire harness so that the marking is at the position shown in the illustration.

    12. B000J8LE02
      Text in Illustration
      *a Vinyl Tape

      Wind vinyl tape around the wire harness to secure it.

      Reference Measurement
      Area Measurement
      a 40.0 mm (1.57 in.)

      Note

      If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.

    13. B000MVK

      Connect each connector to the adapter.

    14. B000NCRE01
      Text in Illustration
      *a Wire harness routing

      Route the longer wire harness as shown in the illustration.

    15. B000LTJE03
      Text in Illustration
      *a Vinyl Tape

      Wind vinyl tape around the wire harness to secure it.

      Reference Measurement
      Area Measurement
      a 40.0 mm (1.57 in.)

  2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY


    1. Connect the connector.

    2. Engage the 2 claws to install the side turn signal light assembly.

  3. INSTALL OUTER MIRROR COVER (except TMC Made)

    w/o Memory: Click here

    w/ Memory: Click here

  4. INSTALL OUTER MIRROR COVER (for TMC Made)


    1. Engage the 7 claws to install the outer mirror cover.

    2. Connect the 2 connectors.

    3. Engage the clamp.

    4. Install the mirror actuator with the 3 screws.

  5. INSTALL OUTER MIRROR (except TMC Made)

    w/o Memory: Click here

    w/ Memory: Click here

  6. INSTALL OUTER MIRROR (for TMC Made)


    1. Connect the 2 connectors.

    2. B000KLJ

      Engage the 2 guides on the upper part of the outer mirror to the outer mirror.

    3. B000HDF

      Engage the 2 claws on the lower part of the outer mirror to the outer mirror.