OUTER REAR VIEW MIRROR (for TMC, TMMR Made) INSTALLATION

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    1. Engage the claw to temporarily install the outer rear view mirror assembly.

    2. Install the outer rear view mirror assembly with the 3 bolts.

      Torque:
      11 N*m  { 107 kgf*cm, 8 ft.*lbf }

    3. Connect the connector.

  2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP


    1. B000MP8

      Install the front door inner glass weatherstrip.

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. B000KO6E01
      Text in Illustration
      *1 Front Door Inside Locking Cable Assembly
      *2 Front Door Lock Remote Control Cable Assembly

      Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

    2. w/o Memory:


      1. Connect the connector.

    3. w/ Memory:


      1. Connect the 2 connectors.

    4. B000KHDE01
      Text in Illustration
      *1 Reference Boss

      Engage the front door trim board sub-assembly with the 4 claws and reference boss as shown in the illustration.

    5. B000NJZ

      Engage the 10 clips and install the front door trim board sub-assembly.

    6. Install the 3 screws.

    7. If protective tape has been applied, remove it.

  4. INSTALL COURTESY LIGHT ASSEMBLY


    1. Connect the connector.

    2. B000I67E01
      Text in Illustration
      *A for LH Side
      *B for RH Side

      Engage the claw to install the courtesy light assembly.

  5. INSTALL FRONT ARMREST ASSEMBLY


    1. B000LDC

      Engage the 2 guides, 3 clips and 7 claws, and install the front armrest assembly.

  6. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. Connect each connector.

    2. B000IAE

      Engage the 4 guides, 2 clips and 5 claws, and install the multiplex network master switch assembly with front door armrest base panel.

  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. Connect the connector.

    2. B000MFS

      Engage the 4 guides, 2 clips and 5 claws, and install the power window regulator switch assembly with front door armrest base panel.

  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


    1. B000LAY

      Engage the 3 clips to install the front door lower frame bracket garnish.

  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. B000HXN

      Engage the 3 claws to install the front door inside handle bezel plug.