HOOD LOCK CONTROL CABLE ASSEMBLY (for TMMK Made) REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. B000JM6

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE FRONT WHEEL LH

  3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  4. REMOVE FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  5. REMOVE FRONT DOOR SCUFF PLATE LH


    1. B000JR7E01

      Disengage the 2 claws (A) in the direction indicated by the arrows (1) shown in the illustration.

    2. Disengage the 2 claws (B) in the direction indicated by the arrows (2) shown in the illustration.

    3. Disengage the 6 claws (C) to remove the front door scuff plate LH.

  6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    1. B000MCM

      Remove the clip.

    2. Pull the cowl side trim sub-assembly LH as shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B000H4N

      Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.

  8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B000LYF

      Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK ASSEMBLY


    1. B000KEJE01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, remove the hood lock nut cap.

      Tech Tips

      Tape the screwdriver tip before use.

    2. w/ Engine Hood Courtesy Switch:


      1. B000L2K

        Disconnect the connector.

    3. B000I1BE01
      Text in Illustration
      *1 Hood Lock Bolt

      Remove the 2 bolts and hood lock bolt.

    4. B000N1F

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.

      B000IG1E01
      Text in Illustration
      *1 Hood Lock Control Cable Assembly *2 Washer Hose
      *a Hood Cable Grommet *b Hood Lock Control Cable Clamp

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.