HOOD (for TMC, TMMR Made) DISASSEMBLY


  1. REMOVE HOOD CENTER CUSHION


    1. B000MKE

      Disengage the 2 claws and remove the 2 hood center cushions.

  2. REMOVE FRONT HOOD MOULDING ASSEMBLY


    1. Apply protective tape around the front hood moulding assembly.

    2. B000MYN

      Remove the 7 nuts and front hood moulding assembly.

  3. REMOVE HOOD TO RADIATOR SUPPORT SEAL


    1. B000MB9

      Using a clip remover, disengage the 8 clips and remove the hood to radiator support seal.

  4. REMOVE HOOD INSULATOR


    1. B000HEO

      Using a clip remover, remove the 7 clips.

    2. Disengage the 2 guides and remove the hood insulator.

  5. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    1. B000I7WE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.

      Note

      Be careful not to damage the windshield.

      Tech Tips

      Tape the screwdriver tip before use.

    2. B000HWL

      Remove the washer nozzle sub-assembly from the washer hose.

      Note

      Washer nozzles cannot be reused.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  6. DISCONNECT WASHER HOSE ASSEMBLY


    1. B000LBL

      Disengage the 6 clamps and disconnect the washer hose assembly.

  7. REMOVE HOOD SUPPORT ASSEMBLY LH

    Note


    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.


    1. B000I9VE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, remove the 2 stop rings as indicated by the arrows, in the order shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Release the ball joint and remove the hood support assembly.

      Note

      Remove the hood support assembly while supporting the hood by hand.

  8. REMOVE HOOD SUPPORT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.