REAR POWER WINDOW SWITCH (for TMC, TMMR Made) INSPECTION

INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door)

1. 

   Text in Illustration

   *a	Component without harness connected (Rear Power Window Regulator Switch Assembly (for LH Door))

   Check the switch function.

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 6 (UP) - 1 (GND) Auto up or up position Below 1 Ω 7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω 8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω 6 (UP) - 1 (GND) Free 10 kΩ or higher 7 (DOWN) - 1 (GND) Free 10 kΩ or higher 8 (AUTO) - 1 (GND) Free 10 kΩ or higher

      If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

2. 

   Text in Illustration

   *a	Component without harness connected (Rear Power Window Regulator Switch Assembly (for LH door))
   *b	LED

   Check that the LED illuminates.

   
   

   1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

      OK
      Measurement Condition Specified Condition Battery positive (+) → 4 (LED) Battery negative (-) → 1 (GND) LED illuminates

      If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Door)

1. 

   Text in Illustration

   *a	Component without harness connected (Rear Power Window Regulator Switch Assembly (for RH Door))

   Check the switch function.

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 6 (UP) - 1 (GND) Auto up or up position Below 1 Ω 7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω 8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω 6 (UP) - 1 (GND) Free 10 kΩ or higher 7 (DOWN) - 1 (GND) Free 10 kΩ or higher 8 (AUTO) - 1 (GND) Free 10 kΩ or higher

      If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).

2. 

   Text in Illustration

   *a	Component without harness connected (Rear Power Window Regulator Switch Assembly (for RH Door))
   *b	LED

   Check that the LED illuminates.

   
   

   1. Apply battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

      OK
      Measurement Condition Specified Condition Battery positive (+) → 4 (LED) Battery negative (-) → 1 (GND) LED illuminates

      If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).