CHILD RESTRAINT SEAT TETHER ANCHOR (for TMMK Made) REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR SEAT CUSHION ASSEMBLY


    1. B000M41E01

      Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.

      Standard Measurement
      a 100 mm (3.94 in.) or less

      Note

      Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.

    2. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.

      Note

      Be careful not to damage the vehicle body.

  4. REMOVE REAR SEAT CUSHION LOCK HOOK


    1. B000LZB

      Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD


    1. B000GXE

      Remove the inner luggage compartment trim pad.

  6. REMOVE REAR SEATBACK ASSEMBLY LH


    1. B000H65E02
      Text in Illustration
      *a Fastener

      Disengage the 2 fasteners as shown in the illustration.

    2. B000HAG

      Remove the 2 bolts and rear seatback assembly LH.

      Note

      Be careful not to damage the vehicle body.

  7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH


    1. Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide.

    2. Disconnect the connector.

    3. B000HU6

      Remove the 2 bolts.

    4. Disengage the hook and remove the rear side seatback assembly LH.

  8. REMOVE REAR SIDE SEATBACK ASSEMBLY RH


    1. Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide.

    2. Disconnect the connector.

    3. B000H5G

      Remove the 2 bolts.

    4. Disengage the hook and remove the rear side seatback assembly RH.

  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. Disconnect the rear door opening trim weatherstrip LH.

  10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH


    1. Disconnect the rear door opening trim weatherstrip RH.

  11. REMOVE ROOF SIDE INNER GARNISH LH


    1. B000NIP

      Disengage the 5 clips.

    2. Disengage the guide and remove the roof side inner garnish LH.

    3. Remove the 5 clips from the roof side inner garnish LH.

  12. REMOVE ROOF SIDE INNER GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side)


    1. B000H1H

      Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.

  14. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side)


    1. B000IIN

      Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.

  15. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    1. B000N8L

      Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.

  16. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    1. for Type A:


      1. B000H32

        Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.

    2. for Type B:


      1. B000LJR

        Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.

  17. REMOVE CENTER STOP LIGHT SET


    1. B000H2KE01

      Slide the center stop light set in the order and directions shown by the arrows in the illustration while pushing it towards the rear of the vehicle to disengage the 4 claws.

    2. B000IPH

      Turn the center stop light set 180 degrees as shown by the arrow in the illustration.

      Tech Tips

      This makes it easier to disconnect the connector.

    3. Disconnect the connector and remove the center stop light set.

  18. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER


    1. B000K4D

      Using a moulding remover, disengage the 2 claws and 2 guides to remove the child restraint seat tether anchor cover.

      Tech Tips

      Use the same procedure for the other 2 child restraint seat tether anchor covers.

  19. REMOVE REAR SEAT SHOULDER BELT COVER


    1. B000N9T

      Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.

      Tech Tips

      Use the same procedure for the other 2 rear seat shoulder belt covers.

  20. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. B000KXZE02
      Text in Illustration
      *a Protective Tape

      Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.

      Tech Tips

      Tape the tip of the pliers before use.

    2. Disengage the 5 guides.

    3. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.

  21. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET


    1. B000LV1

      Remove the bolt and child restraint seat tether anchor bracket.

      Tech Tips

      Use the same procedure for the other 2 child restraint seat tether anchor brackets.