OCCUPANT CLASSIFICATION ECU (for TMMK Made) INSTALLATION


  1. INSTALL OCCUPANT DETECTION ECU


    1. B000M0L

      Engage the claw to install the occupant detection ECU.

      Note

      If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

    2. Connect the 2 connectors.

      Note

      When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.

  2. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

    Click here

  3. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

    Tech Tips

    Use the same procedure for the RH side and LH side.

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

    Click here