FRONT PASSENGER AIRBAG ASSEMBLY (for TMC, TMMR Made) INSTALLATION

INSTALL NO. 2 INSTRUMENT PANEL WIRE

Text in Illustration
*1	Airbag Connector
*2	Airbag Connector Lock

Connect the airbag connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

Note

When connecting any airbag connector, take care not to damage the airbag wire harness.

Push in the lock to install the airbag connector to the instrument panel passenger airbag assembly.
Engage the clamp.

INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Note

If the hooks are not engaged in the correct order, the deployment part of the instrument panel passenger airbag assembly may be damaged.
1. Engage the 3 hooks as shown in the illustration.
2. Push the instrument panel passenger airbag assembly to engage the 3 hooks.
3. Install the 2 screws to install the instrument panel passenger airbag assembly.
INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
1. Engage the 5 guides and temporarily install the instrument panel safety pad assembly as shown in the illustration.
  Note
  
  Do not damage the instrument panel safety pad assembly.
  
  Do not allow the wire harnesses to interfere with the surrounding parts.
2. Install the 2 clips.
3. Install the 3 bolts <B> and nut <F> or <G>.
4. Install the 2 passenger airbag bolts <A>.
  
  Torque:
  
  20 N*m { 204 kgf*cm, 15 ft.*lbf }
5. Install the glove box light as shown in the illustration.
6. Engage each clamp.
7. Connect each connector.
CONNECT NO. 2 INSTRUMENT PANEL WIRE
1. Check that the ignition switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Connect the connector.
  
  Note
  
  When connecting any airbag connector, take care not to damage the airbag wire harness.
INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Click here
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here