STEERING PAD (for TMC, TMMR Made) INSTALLATION


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B000KK7E01
      Text in Illustration
      *a Airbag Connector
      *b Horn Connector
      *c Airbag Connector Lock

      Connect the airbag connector to the horn button assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. Connect the horn connector to the horn button assembly.

    6. B000NR5

      Push the horn button assembly to engage the 3 pins carefully and install the horn button assembly.

      Note


      • Make sure that the pins are securely inserted into the steering wheel assembly holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

  2. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. B000J98

      Engage the claw and guide to install the lower No. 3 steering wheel cover.

  3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. B000IM4

      Engage the claw and guide to install the lower No. 2 steering wheel cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system Click here.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. INSPECT SRS WARNING LIGHT

    Click here