ELECTRICAL KEY OSCILLATOR (for Center Floor) INSTALLATION


  1. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMC, TMMR Made)


    1. Install the No. 2 indoor electrical key antenna assembly with the 2 bolts.

      Note

      Be careful when installing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

    2. Connect the connector.

  2. INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMMK Made)


    1. Engage the clamp to install the No. 2 indoor electrical key antenna assembly.

      Note

      Be careful when installing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

    2. Connect the connector.

  3. INSTALL REAR SEAT CUSHION LOCK HOOK (for TMC, TMMR Made)


  4. INSTALL REAR SEAT CUSHION LOCK HOOK (for TMMK Made)


    1. B000HKU

      Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  5. INSTALL REAR SEAT CUSHION ASSEMBLY (for TMC, TMMR Made)


  6. INSTALL REAR SEAT CUSHION ASSEMBLY (for TMMK Made)


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.

    3. B000KWO

      Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.

    4. Confirm that the rear seat cushion assembly is securely installed.

      Note

      When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.