ELECTRICAL KEY OSCILLATOR (for Center Floor) REMOVAL

REMOVE REAR SEAT CUSHION ASSEMBLY (for TMC, TMMR Made)
- for Fold Down Seat Type: Click here
- for Reclining Seat Type: Click here
REMOVE REAR SEAT CUSHION ASSEMBLY (for TMMK Made)
1. Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
  
  Standard Measurement
  
  a 100 mm (3.94 in.) or less
  
  Note
  
  Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.
2. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
  
  Note
  
  Be careful not to damage the vehicle body.
REMOVE REAR SEAT CUSHION LOCK HOOK (for TMC, TMMR Made)
- for Fold Down Seat Type: Click here
- for Reclining Seat Type: Click here
REMOVE REAR SEAT CUSHION LOCK HOOK (for TMMK Made)
1. Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
  
  Note
  
  Rear seat cushion lock hooks must not be reused.
  
  Tech Tips
  
  Use the same procedure for the RH side and the LH side.
REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMC, TMMR Made)
1. Disconnect the connector.
2. Remove the 2 bolts and No. 2 indoor electrical key antenna assembly.
  
  Note
  
  Be careful when removing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.
REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMMK Made)
1. Disconnect the connector.
2. Disengage the clamp to remove the No. 2 indoor electrical key antenna assembly.
  
  Note
  
  Be careful when removing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.