ELECTRICAL KEY OSCILLATOR (for Front Floor) INSTALLATION


  1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. Connect the connector.

    2. Install the No. 1 indoor electrical key antenna assembly with the bolt.

      Note

      Be careful when installing the No. 1 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

    3. Engage the clamp.

  2. INSTALL NO. 4 CONSOLE BOX DUCT (for TMC, TMMR Made)


    1. Engage the claw to install the No. 4 console box duct.

  3. INSTALL UPPER CONSOLE BOX SUB-ASSEMBLY (for TMC, TMMR Made)


    1. Connect the 2 connectors.

    2. Engage the clamp.

    3. B000MYF

      Engage the 2 guides and 4 clips as shown in the illustration.

    4. Install the upper console box sub-assembly with the 2 screws.

  4. INSTALL REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMC, TMMR Made)


    1. Connect each connector.

    2. B000KVX

      Engage the 6 clips to install the rear console upper panel sub-assembly.

    3. Move the shift lever to P.

  5. INSTALL FRONT PANEL GARNISH RH (for TMC, TMMR Made)


    1. B000KNC

      Engage the 3 clips and 8 guides to install the front panel garnish RH.

  6. INSTALL FRONT PANEL GARNISH LH (for TMC, TMMR Made)


    1. B000N75

      Engage the 3 clips and 8 guides to install the front panel garnish LH.

  7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for TMC, TMMR Made)


    1. B000KNB

      Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.

  8. INSTALL NO. 4 CONSOLE BOX DUCT (for TMMK Made)


    1. Engage the claw to install the No. 4 console box duct.

  9. INSTALL REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMMK Made)


    1. Engage the 6 clips.

    2. Install the rear console upper panel sub-assembly with the 2 screws <C> or <D>.

    3. Connect the connector.

    4. Move the shift lever to P.

  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for TMMK Made)


    1. B000H3S

      Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.

    2. B000HP9

      Engage the 2 claws as shown in the illustration.

  11. INSTALL UPPER CONSOLE BOX SUB-ASSEMBLY (for TMMK Made)


    1. w/ Seat Heater System:


      1. Connect each connector.

    2. Engage the 4 clips to install the upper console box sub-assembly.