ELECTRICAL KEY OSCILLATOR (for Front Floor) REMOVAL


  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for TMC, TMMR Made)


    1. B000HON

      Disengage the 2 claws and disconnect the shift hole cover sub-assembly as shown in the illustration.

    2. B000IEY

      Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

  2. REMOVE FRONT PANEL GARNISH LH (for TMC, TMMR Made)


    1. B000IYJ

      Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.

  3. REMOVE FRONT PANEL GARNISH RH (for TMC, TMMR Made)


    1. B000MWG

      Disengage the 3 clips and 8 guides to remove the front panel garnish RH.

  4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMC, TMMR Made)


    1. Move the shift lever to N.

    2. Disengage the 6 clips as shown in the illustration.

      B000K6G

    3. Disconnect each connector to remove the rear console upper panel sub-assembly.

  5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY (for TMC, TMMR Made)


    1. B000IFZ

      Remove the 2 screws.

    2. B000HUF

      Disengage the 4 clips and 2 guides as shown in the illustration.

    3. B000IEK

      Disengage the clamp.

    4. Disconnect the 2 connectors to remove the upper console box sub-assembly.

  6. REMOVE NO. 4 CONSOLE BOX DUCT (for TMC, TMMR Made)


    1. B000MX2

      Disengage the claw and remove the No. 4 console box duct.

  7. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY (for TMMK Made)


    1. B000NK9

      Disengage the 4 clips and remove the upper console box sub-assembly.

    2. w/ Seat Heater System:


      1. Disconnect each connector.

  8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for TMMK Made)


    1. B000JA9

      Disengage the 2 claws as shown in the illustration.

    2. B000NQD

      Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

  9. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMMK Made)


    1. Move the shift lever to N.

    2. B000MQT

      Disconnect the connector.

    3. Remove the 2 screws <C> or <D>.

    4. B000MVY

      Disengage the 6 clips and remove the rear console upper panel sub-assembly.

  10. REMOVE NO. 4 CONSOLE BOX DUCT (for TMMK Made)


    1. B000MX2

      Disengage the claw and remove the No. 4 console box duct.

  11. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. B000MTG

      Disengage the clamp.

    2. Remove the bolt.

    3. Disconnect the connector to remove the No. 1 indoor electrical key antenna assembly.

      Note

      Be careful when removing the No. 1 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.