PRECAUTION FOR DISCONNECTING THE BATTERY CABLE
Note
When disconnecting the battery negative (-) cable, initialize the following system after the cable is reconnected
| System Name | See Procedure |
|---|---|
| Parking Assist Monitor System |
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester to troubleshoot with the ignition switch off:
Connect the intelligent tester to the DLC3, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned to ON.
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY EXPRESSIONS
The type of multiplex network master switch assembly used on this model differs depending on the specifications of the vehicles. The expressions listed in the table below are used in this section.
| Vehicle Specification | Part Name in Manual | Actual Part Name |
|---|---|---|
| w/ Jam Protection Function on 4 Windows | Multiplex network master switch assembly | Multiplex network master switch assembly |
| w/ Jam Protection Function on Front Door Windows | Multiplex network master switch assembly | Power window regulator master switch assembly |